AEG FAVORIT 44082 i 사용자 정보 - 페이지 11

{카테고리_이름} AEG FAVORIT 44082 i에 대한 사용자 정보을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG FAVORIT 44082 i 40 페이지. Aeg dishwasher favorit

Setting the amount of rinse aid required

Only change the amount dispensed, if smears, milky spots (reduce the

amount) or dried on water spots (increase the amount) can be seen on

glasses and dishes. (See section "If dishwashing results are not satisfac-

tory".) The dosage can be set from 1-6. The dosage is pre-set to "4" in

the factory.

1. Open the dishwasher door.

2. Press the release button on the rinse

aid compartment.

3. Open the cover.

4. Set the dosage level.

5. Press the lid shut until it clicks into

place.

6. If rinse aid has leaked out, wipe it

away with a cloth.

Activating rinse aid inflow when 3in1 function is se-

lected

If the 3in1 function is not selected, the rinse aid inflow is always acti-

vated.

If the 3in1 function is selected due to the use of 3in1 detergent, the

rinse aid inflow is deactivated. If the dishes then do not dry sufficiently,

you should re-activate the rinse aid inflow (see also section "Using 3in1

detergents").

1. Press the ON/OFF button.

If the only LED indicator illuminated is one that belongs to a pro-

gramme button, this means that this dishwashing cycle has been acti-

vated. The dishwashing cycle must be deselected:

Press function buttons 2 and 3 simultaneously for approx. 2 seconds.

The LED indicators of all the programme buttons that can be selected

light up.

2. Press function buttons 2 and 3 simultaneously and keep them pressed.

The LED indicators for function buttons 1 to 3 will flash.