Fujitsu AB G18LVTB Series 디자인 및 기술 매뉴얼 - 페이지 26

{카테고리_이름} Fujitsu AB G18LVTB Series에 대한 디자인 및 기술 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu AB G18LVTB Series 45 페이지.

페이지 인쇄

1-4. Heater room temperature correction

Depending on the installed environment, the room temperature sensor may require a correction.

The settings may be changed as shown in the table below.

Setting Description

Standard



Lower control

Slightly warmer control

Warmer control

When using floor console installation, change the setting value to "1".

1-5. Auto restart

The following settings are also possible, depending on the operating conditions.

Setting Description

Yes



1-6. Indoor room temperature sensor switching function

(Only for Wired remote controller)

The following settings are needed when use the control by Wired remote controller temperature

sensor.

Setting Description



Yes

If setting value is "00",

•

room temperature is controlled by the indoor unit temperature sensor.

If setting value is "01",

•

room temperature is controlled by either indoor unit temperature sensor or remote controller unit sensor.

1-7. Remote controller signal code

Change the indoor unit Signal Code, depending on the remote controllers.

Setting Description



1-8. External input control

"Operation/Stop" mode or "Forced stop" mode can be selected.

Setting Description

Operation/Stop mode



(Setting forbidden)

Forced stop mode

(  . . .Factory setting)

Function Number

Setting Value

(  . . .Factory setting)

Function Number

Setting Value

(  . . .Factory setting)

Function Number

Setting Value

(  . . .Factory setting)

Function Number

Setting Value

(  . . .Factory setting)

Function Number

Setting Value

- (01 - 23) -