A-I-R ATOS Series 운영 매뉴얼 - 페이지 6

{카테고리_이름} A-I-R ATOS Series에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. A-I-R ATOS Series 20 페이지.

12.) Lift the right wing wing tip until the nose fitting engages. When lifting the wing, make sure that

the other wing does not slip backwards.

13.) Secure the bolt with a safety ring.

14.) Remove the Velcro straps and wingtip bags and stretch the sail outwards

Take care not to bend the spoilers - they can break!

15.) Insert the aluminum outer wing tubes (green - right, red - left). Open the sail on the wingtip

and insert the wing tube. Reach through the hole under the spoiler with the other hand and

insert the tube into the D-spar. Important: Insert the tube as far as it will go, so the triangle

mark is flush with the spar.

16.) Insert the winglet into the outer tube, making sure that the spring catches engage.

17.) Pull out the carbon shells and press onto the Velcro so the shell is connected to

at the wing tip and D -spar

18.) Reach inside the sail from the wingtip and connect the outermost three ribs.

19.) Unfold and attach the outermost rib on the carbon fiber spar by reaching into the access holes

in the sail. Secure the outermost 4 ribs with bungees.

Page 6