Brother RuggedJet RJ-2050 빠른 설정 매뉴얼 - 페이지 5
{카테고리_이름} Brother RuggedJet RJ-2050에 대한 빠른 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Brother RuggedJet RJ-2050 9 페이지. Rd rolls
Brother RuggedJet RJ-2050에 대해서도 마찬가지입니다: 제품 안전 매뉴얼 (16 페이지)
페이지 인쇄
Removing the Receipt/Label Roll
For RJ-2030/2050
1.
Pull the cover open lever in the direction shown to open the media roll
compartment cover.
2.
Remove the roll.
NOTE
It is not necessary to adjust the roll holder once it is correctly adjusted to
the media roll width.
For RJ-2140/2150
1.
Pull the cover open lever in the direction shown to open the media roll
compartment cover.
2.
While pushing the roll release lever, tilt the roll guide slightly, and then
remove the roll. The roll can be removed without changing the position
of the roll guide.
Do not forcefully tilt the roll guide too far. Otherwise, the roll guide could
break.
1
Roll release lever
1
1
2
Attaching the Belt Clip
The printer can be carried on your belt by attaching the included belt clip.
Follow the instructions below to attach the clip to the printer and your belt.
You can attach the included clip to your printer and secure it to your belt.
1.
Secure the belt clip to the rear of your printer using the Phillips-head
screws as shown:
2
1
1
Belt clip
2
Phillips screw
2.
Attach the clip to your belt.
Turn the clip as shown to lock
the belt clip.
IMPORTANT
Make sure you attach the belt clip securely to your printer and to your
belt. There is a risk of injury or damage if the belt clip is not attached
securely and your printer falls.
Turn the clip to the left or right
to unlock the belt clip.