Brother RuggedJet RJ-4040 사용자 설명서 - 페이지 26

{카테고리_이름} Brother RuggedJet RJ-4040에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Brother RuggedJet RJ-4040 33 페이지. Multi-protocol on-board ethernet print server and wireless ethernet print server
Brother RuggedJet RJ-4040에 대해서도 마찬가지입니다: 빠른 참조 매뉴얼 (2 페이지), 소프트웨어 설명서 (48 페이지), 빠른 참조 매뉴얼 (1 페이지), 사용자 설명서 (34 페이지), 제품 안전 매뉴얼 (22 페이지)

페이지 인쇄

Appendix B

Configuring your printer for a network

IP addresses, subnet masks and gateways

To use the printer in a networked TCP/IP environment, you need to configure its IP address and subnet mask.

The IP address you assign to the print server must be on the same logical network as your host computers.

If it is not, you must properly configure the subnet mask and the gateway address.

IP address

An IP address is a series of numbers that identifies each device connected to a network. An IP address

consists of four numbers separated by dots. Each number is between 0 and 255.



Example: In a small network, you would normally change the final number.

• 192.168.1.1

• 192.168.1.2

• 192.168.1.3

How the IP address is assigned to your print server:

If you have a DHCP/BOOTP/RARP server on your network the print server will automatically obtain its IP

address from that server.

Note

On smaller networks, the DHCP server may also be the Router.

For more information on DHCP, BOOTP and RARP, see:

Using DHCP to configure the IP address uu page 26.

Using BOOTP to configure the IP address uu page 27.

Using RARP to configure the IP address uu page 26.

If you do not have a DHCP/BOOTP/RARP server, the Automatic Private IP Addressing (APIPA) protocol will

automatically assign an IP address from the range 169.254.1.0 to 169.254.254.255. For more information on

APIPA, see Using APIPA to configure the IP address uu page 27.