Brother P-TOUCH CUBE 사용자 설명서 - 페이지 12

{카테고리_이름} Brother P-TOUCH CUBE에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Brother P-TOUCH CUBE 18 페이지. Tze tape
Brother P-TOUCH CUBE에 대해서도 마찬가지입니다: 사용자 설명서 (18 페이지), 사용자 설명서 (25 페이지), 사용자 설명서 (18 페이지), 사용자 설명서 (18 페이지)

페이지 인쇄

2. Install Batteries or Connect the AC Adapter

CAUTION

ALWAYS USE THE SPECIFIED VOLTAGE AND THE AC ADAPTER (AD-24ES/AD-

24ESA/AD-24ESAW/AD-24ESA-01/AD-24ESAW-01) FOR THE LABEL PRINTER TO

PREVENT ANY DAMAGE OR FAILURE.

This label printer requires six (6) AAA alkaline batteries or six (6) fully-charged AAA Ni-MH

batteries, not included. As an alternative, use the AC Adapter included with this machine

and plug the label printer into an AC outlet.

1. Hold the label printer as shown in

the illustration. Open the Battery

Cover by pressing the mark on its

side (1) and pulling in the direction of

the arrow (2).

2. Insert six batteries following the

drawing marked inside the case.

Alternate positive and negative

poles, making sure to match the

negative battery end with the coil in

the battery slot.

3. Insert the two hooks at the rear of

the Battery Cover into the slots on

the label printer (3). Push the

Battery Cover closed (4), making

sure it locks into place.

The coils are

negative pole