Fujitsu S510M - ScanSnap - Document Scanner 시작하기 매뉴얼 - 페이지 12
{카테고리_이름} Fujitsu S510M - ScanSnap - Document Scanner에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu S510M - ScanSnap - Document Scanner 35 페이지. Color image scanner
Fujitsu S510M - ScanSnap - Document Scanner에 대해서도 마찬가지입니다: 설치 절차 (3 페이지), 사양 (2 페이지), 빠른 설치 매뉴얼 (2 페이지), 시작하기 매뉴얼 (24 페이지), 청소 지침 (2 페이지), 청소 지침 (2 페이지)
페이지 인쇄
Stacker
Operation button
■
Rear view
■
USB connector
Seal (reminds you that the supplied
software has to be installed first)
After installing the software, remove this seal.
For the Document Specification, refer to "3.2 Paper Sizes of Documents to be Scanned"
in "ScanSnap S510M Operator's Guide" stored in the ScanSnap Setup CD-ROM.
The ScanSnap is turned on/off in conjunction with the connected computer, or with
ATTENTION
opening/closing of the paper chute. Ordinary, you can forget about turning on/off the
ScanSnap.
11
Before using the stacker, unfold and extend it as shown above.
⇒
You can also use the ScanSnap without unfolding the stacker.
SCAN
POWER
Paper chute
After opening it, load the documents to be
scanned on this part.
Side guide
Adjust the side guides to the width of
documents so that the scanned images will
not be skewed.
Cover open lever
To open the ADF, pull this lever toward
you.
Operation button
[SCAN] button
Press this button to start the scanning.
[Power] button
Turns on/off the power.
Power Indicator
Indicates the power status of the ScanSnap.
Blue (Solid):
Ready
Blue (Blinking):Scanning
Orange (Solid): Error
Light off:
Power off
AC adapter connector
Security cable slot
Plug a commercially available
security cable into this slot
(anti-theft).