Fujitsu ScanSnap S300 시작하기 매뉴얼 - 페이지 20

{카테고리_이름} Fujitsu ScanSnap S300에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu ScanSnap S300 37 페이지. Color image scanner
Fujitsu ScanSnap S300에 대해서도 마찬가지입니다: 설치 절차 (3 페이지), 사양 (2 페이지), 청소 지침 (2 페이지)

페이지 인쇄

• Be sure to use the supplied AC adapter and AC cable.

ATTENTION

• Be sure to use the supplied USB cable.

• If only the USB cable is used, the ScanSnap does not operate. Be

• When connecting to a USB hub, be sure to use the first stage USB

• When connecting with a USB 2.0 cable, make sure that the USB port

When connecting with the USB bus power cable:

•

Use the USB bus power cable

Connect the USB bus power cable.

Remove the adhesive label covering the USB and Power connectors

Connect to the ScanSnap's Power connector and a personal computer.

Connect the USB cable.

Connect the USB cable to both the ScanSnap and personal computer.

USB connector

After power and USB ports are connected with cables, perform the

procedure described in "Turning the ScanSnap ON" (page 20).

The operation with any commercially available USB cable is not

guaranteed.

sure to use two types of cables, Power and USB cables, to connect

the ScanSnap to a personal computer.

hub that is closest to the computer. If you use the second or later hub

stages, the scanner may not operate properly.

to connect to and hub must be USB 2.0-compliant. Note that if

connected with a USB 1.1 cable, the scanning speed may become

slow. When a USB 2.0-compliant port is available, it is recommended

that the USB 2.0-compliant port be used.

and USB cable

Power connector

USB port