Fujitsu ScanSnap S300 시작하기 매뉴얼 - 페이지 31

{카테고리_이름} Fujitsu ScanSnap S300에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu ScanSnap S300 37 페이지. Color image scanner
Fujitsu ScanSnap S300에 대해서도 마찬가지입니다: 설치 절차 (3 페이지), 사양 (2 페이지), 청소 지침 (2 페이지)

페이지 인쇄

Symptom

Scanning

Does the

does not

continuously?

start.

Did you resume the computer

from the hibernation state?

Is ScanSnap Manager started?

(If ScanSnap Manager is

started up successfully, the

[ScanSnap Manager] icon

appears on the task bar.)

Is ScanSnap Manager running

properly?

(If ScanSnap Manager is not

running properly, the

[ScanSnap Manager] icon in the

task bar is displayed as

The scanner

Did you connect the scanner to

is not

your PC before installing

recognized

ScanSnap Manager?

even if

Is the scanner registered as

ScanSnap

"Other Device" or "Unknown

Manager is

Device" in the "Device

installed.

Manager"?

Check This Item

LED light blink

Disconnect the power or USB bus power

cable and connect it again.

(Note: Wait at least 5 seconds before

reconnecting the power or USB bus power

cable.)

When you perform scanning after resuming

the computer from the hibernation state,

move the mouse or press any key before

scanning.

If the [ScanSnap Manager] icon is not

displayed, select [Start]

[ScanSnap Manager]

to start ScanSnap Manager.

Do the following:

1.Update ScanSnap Manager driver.

On the [Start] menu, select [Control

panel]

[System]

[Device Manager].

In the [Device Manager], right-click

[ScanSnap S300] and select [Update

Driver] from the menus displayed. If this

does not improve the situation, perform

step 2.

2.Turn the ScanSnap OFF and ON again. If

this does not improve the situation,

perform step 3. (Note: Wait at least 5

seconds before turning the scanner on.)

3.If a USB hub is used, directly connect the

ScanSnap to your PC. If this does not

improve the situation, perform step 4.

4.Restart your PC.

If none of the above operations resolve the

problem, uninstall and re-install ScanSnap

Manager.

For how to uninstall ScanSnap Manager,

refer to "Appendix B Uninstalling

ScanSnap" in "ScanSnap S300

Operator's Guide."

On the [Start] menu, select [Control panel]

[System]

Manager]. Delete the device name such as

USB device (differs with the OS) under

"Other Device" selection in the [Device

Manager] and restart your PC.

ScanSnap S300 Getting Started　

Remedy

[All Programs]

[ScanSnap Manager]

[Hardware]

[Device