Fujitsu Eternus DX200F 구성 매뉴얼 - 페이지 21

{카테고리_이름} Fujitsu Eternus DX200F에 대한 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu Eternus DX200F 38 페이지. Hybrid storage systems, all-flash arrays, power synchronized unit
Fujitsu Eternus DX200F에 대해서도 마찬가지입니다: 운영 매뉴얼 (48 페이지), 설정 매뉴얼 (10 페이지), 구성 매뉴얼 (28 페이지), 구성 매뉴얼 (13 페이지), 구성 매뉴얼 (16 페이지), 안전 주의사항 (12 페이지)

페이지 인쇄

1. Hardware

Chapter 8

Installing Drivers and Setting Up the Server

8.1

Installing the Driver

Install the necessary drivers and patches following the Fibre Channel card installation guide.

8.2

Setting Up the Driver Parameters

8.2.1

For AIX Configurations (Configurations other than a VIOS/VIOC Configuration)

Use the "smit" command and other commands to set the driver parameters.

If an "fscsiN" entry (where "N" is a number) corresponding to the Fibre Channel card is displayed, delete

the hdisk device (child device of the fscsiN device) temporarily using the "rmdev" command to change the

fscsiN device parameter.

The deleted hdisk device (child device of the fscsiN device) is recreated after the server is rebooted or

when the "cfgmgr" command is executed. Enter the target fscsi number for "N".

For a SAN Boot configuration, apply the change only to the database without deleting the hdisk device

and then reboot the server.

# rmdev -p fscsiN

Set the parameter as shown in the following table.

Parameter

init_link

num_cmd_elems

*1: Recommended value = 1024 ¸ (number of Fibre Channel ports that are connected to a single CA port)

(Round the result down)

FUJITSU Storage ETERNUS DX, ETERNUS AF Configuration Guide -Server Connection- (Fibre Channel) for AIX

Setting target

fcs

Setting value

•

For direct connections,

select [al].

For switch connections,

•

select [pt2pt].

Arbitrary (*1)

(Up to 1024 for each FC

port of the ETERNUS

DX/AF)

Remarks

This setting is fixed to "Au-

to" for some Fibre Channel

cards (e.g. 5735), and can-

not be changed. Use those

HBAs as they are, in the

"Auto" setting.

—

P3AM-3782-23ENZ0