Chapter 2
Setting Up the ETERNUS DX
2.1
Common Settings
2.1.3
Setting the Host Responses
The host response parameters for the ETERNUS DX must be set to match the way the server processes the
responses to requests from the ETERNUS DX. Setting of the host response must be done before connecting
the ETERNUS DX to the server.
Set the parameters that are described below for each OS.
Retain the default values for all of the parameters that are not described below.
Since "Windows EMPD", "Linux EMPD", "Solaris EMPD", or "Others" cannot be selected after applying the
latest firmware, select "Default" for the Host Response setting.
Note that these items are displayed as the existing setting, but do not need to be changed.
Table 2.2 Host response settings
OS
Solaris
®
Windows
VMware ESX
Linux
2.1.4
Setting the CA Port Groups
Create new SAS port groups and register the ports as members of the groups. A SAS port group is a group of
SAS-CA type ports that are connected to the specified host group. Configure the host affinity setting for each
SAS port group.
Conditions
When all of the following con-
ditions are met
The OS standard Multipath
•
Driver (MPxIO) is used
The Multipath Diagnostic
•
Program (or Enhanced Sup-
port Facility 5.1 or later) is
installed
When MPxIO that is different
from the above is used
When the ETERNUS Multipath
Driver or Symantec Storage
Foundation is used
–
For SUSE Linux Enterprise
Server 10
Other cases
FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection-
Copyright 2014 FUJITSU LIMITED
Host response selec-
Parameter
tion
None
Reservation Conflict Re-
sponse for Test Unit
(Create a new host re-
Ready
sponse)
Sense Data Conversion
Solaris MPxIO
–
Default
–
Default
–
None
Sense Data Conversion
(Create a new host re-
sponse)
Default
–
9
Setting value
Conflict
4/*/* g 6/*/*
B/*/* g 6/*/*
–
–
–
b/c1/01 g 6/c1/01
–
P3AM-5352-11ENZ0
페이지 인쇄