Fujitsu ETERNUS DX8700 S2 구성 매뉴얼 - 페이지 18

{카테고리_이름} Fujitsu ETERNUS DX8700 S2에 대한 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu ETERNUS DX8700 S2 28 페이지. Disk storage system settings
Fujitsu ETERNUS DX8700 S2에 대해서도 마찬가지입니다: 사용자 설명서 (35 페이지), 사용자 설명서 (42 페이지), 구성 매뉴얼 (15 페이지)

페이지 인쇄

1. Hardware

Chapter 6

Installing the iSCSI Software Initiator and Setting Up the Server

6.2

Setting Up the Server

Confirm the iSCSI Initiator name.

Use the "iscsiutil" command to check the iSCSI Initiator name.

The iSCSI Initiator name shown here is used for the ETERNUS DX settings.

# iscsiutil -l

Save the statically-recognized iSCSI target information in the kernel registry.

Use the "iscsiutil" command to save the iSCSI target information.

# iscsiutil [iscsi-device-file] -a -I <ip-address>

Example:

For an ETERNUS DX with a connection target iSCSI port IP address of 192.1.1.120:

# iscsiutil -a -I 192.1.1.120

Confirm the iSCSI target information is now in the kernel registry.

# iscsiutil -p -D

Set whether CHAP authentication is to be used or not.

If CHAP authentication is to be performed, set "CHAP". If CHAP authentication is not required, set

"None".

Example:

When CHAP authentication is not used:

# iscsiutil -t authmethod None

Note:

# iscsiutil -t authmethod CHAP None

The above command sets CHAP authentication to operate according to the ETERNUS DX setting. The

CHAP authentication method is selected if the ETERNUS DX uses CHAP for its responses, otherwise CHAP

authentication is not performed.

FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection- (iSCSI) for HP-UX

[-P <tcp-port>][-M <portal-grp-tag>]

P3AM-3402-14ENZ0