AEG OKO-LAVAMAT BELLA2100 지침 책자 - 페이지 43

{카테고리_이름} AEG OKO-LAVAMAT BELLA2100에 대한 지침 책자을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG OKO-LAVAMAT BELLA2100 45 페이지. Aeg the environmentally friendly washing machine

페이지 인쇄

Unscrew the two plastic screws (4 - Fig. A) and fit them on the oppo-

site side (4 - Fig. B).

Remove the catch hook (5 - Fig. A) by inserting a screwdriver into the

upper hole and pushing downwards.

Remove plate (6) by inserting a screwdriver into the bottom hole and

pushing upwards (Fig. A).

Refit the catch hook (5) and plate (6) on the opposite sides (Fig. B).

Remove the door catch (7) and plate (8) as explained in paragraph 7.

Turn the door 180°.

Refit the door catch (7) and plate (8), reversing their position and

pressing firmly to engage the hook (Fig. B).

Fit the door onto the machine. Insert the top pin first, then the bot-

tom pin into the hinge (3- Fig. B); finally screw the hinge onto the

washing machine.

Check that the door is aligned with the appliance. To do this, loosen

screw (9 - Fig. B) by a couple of turns and re-tighten when alignment

is correct.

Fit the flexible end of the door catch (1 - Fig. B) into the location

provided in the door.

Fitting a door panel

The door of this machine has mouldings to allow fitting of a decorati-

ve panel (stainless steel sheet, laminated plastic, wood etc.) to match

with the existing kitchen units.

The dimensions of the panel must be as follows:

Width

Height

Maximum thickness

To fit the panel, remove the moulding by unscrewing its fixing screws.

Position the panel, then refit the moulding, making sure that it comes

into contact with and firmly clamps the panel.

588 mm

4 mm

Installation