Brother QL-580N 네트워크 사용 설명서 - 페이지 34

{카테고리_이름} Brother QL-580N에 대한 네트워크 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Brother QL-580N 42 페이지. Label printer
Brother QL-580N에 대해서도 마찬가지입니다: 소프트웨어 사용 설명서 (40 페이지), 네트워크 사용 설명서 (48 페이지), 소프트웨어 사용 설명서 (48 페이지), 사용자 설명서 (26 페이지), 사용자 설명서 (40 페이지), 설정 및 운영 매뉴얼 (43 페이지), 사용자 설명서 (41 페이지)

Note

In order to enable BOOTP, simply use an editor to delete the"#" (if there is no "#", then BOOTP is already

enabled). Then edit the BOOTP configuration file (usually /etc/bootptab) and enter the name, network type

(1 for Ethernet), Ethernet address and the IP address, subnet mask and gateway of the print server.

Unfortunately, the exact format for doing this is not standardized, so you will need to see your system

documentation to determine how to enter this information (many UNIX

examples in the bootptab file that you can use for reference). Some examples of typical /etc/bootptab

entries include:

BRN008077310107 1

and:

BRN008077310107:ht=ethernet:ha=008077310107:\

ip=192.168.1.2:

Certain BOOTP host software implementations will not respond to BOOTP requests if you have not included

a download filename in the configuration file. If this is the case, simply create a null file on the host and specify

the name of this file and its path in the configuration file.

As with RARP, the print server will load its IP address from the BOOTP server when the machine is powered

on.

Using RARP to configure the IP address

The Brother print server's IP address can be configured using the Reverse ARP (RARP) facility on your host

computer. This is done by editing the /etc/ethers file (if this file does not exist, you can create it) with an

entry similar to the following:

00:80:77:31:01:07

Where the first entry is the Ethernet address of the print server and the second entry is the name of the print

server (the name must be the same as the one you put in the /etc/hosts file).

If the RARP daemon is not already running, start it (depending on the system the command can be rarpd,

rarpd -a, in.rarpd -a or something else; type man rarpd or see your system documentation for

additional information). To verify that the RARP daemon is running on a Berkeley UNIX

the following command:

ps -ax | grep -v grep | grep rarpd

For AT&T UNIX

-based systems, type:

ps -ef | grep -v grep | grep rarpd

The Brother print server will get the IP address from the RARP daemon when the printer is powered on.

00:80:77:31:01:07 192.168.1.2

BRN008077310107

systems also have template

-based system, type

Appendix A