AEG OKO - SANTO 3244-4 i 작동 및 설치 지침 - 페이지 14
{카테고리_이름} AEG OKO - SANTO 3244-4 i에 대한 작동 및 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG OKO - SANTO 3244-4 i 28 페이지. Integrating fridge freezer
AEG OKO - SANTO 3244-4 i에 대해서도 마찬가지입니다: 작동 및 설치 지침 (28 페이지)
페이지 인쇄
Symptom
Appliance does not work.
Appliance cools too much.
The food is too warm.
Interior lighting does not
work.
Heavy build up of frost, pos-
sibly also on the door seal.
The compressor does not
start immediately after chan-
ging the temperature set-
ting.
Water on the floor or on sto-
rage shelves.
14
Possible Cause
Appliance is not switched on Switch on the appliance.
Mains plug is not plugged in
or is loose.
Fuse has blown or is defec-
tive.
Socket is defective.
Temperature is set too cold. Turn the temperature control
Temperature is not properly
adjusted.
Door was open for an exten-
ded period.
A large quantity of warm food
was placed in the appliance
within the last 24 hours.
The appliance is near a heat
source.
Light bulb is defective.
Door seal is not air tight
(possibly after reversing the
door).
This is normal, no error has
occurred.
Water drain hole is blocked.
Remedy
Insert mains plug.
Check fuse, replace if
necessary.
Mains malfunctions are to be
corrected by an electrician.
knob to a warmer setting.
Please look in the "Initial
Start Up" section.
Open the door only as long
as necessary.
Turn the temperature control
knob to a colder setting.
Please look in the "Installa-
tion location" section.
Please look in the "Chan-
ging the Light Bulb" section.
Carefully warm the leaking
sections of the door seal
with a hair dryer (not hotter
than approx. 50 °C). At the
same time shape the war-
med door seal by hand until
it sits correctly.
The compressor starts after
a period of time.
See the "Cleaning and
Care" section.