A-Neu Video HD-88 Series 사용 설명서 - 페이지 5

{카테고리_이름} A-Neu Video HD-88 Series에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. A-Neu Video HD-88 Series 18 페이지. Matrix / routing switcher series rs-232 protocol table
A-Neu Video HD-88 Series에 대해서도 마찬가지입니다: 사용 설명서 (10 페이지)

페이지 인쇄

EDID FUNCTION FOR HDMI MATRIX SWITCHER

To view the current EDID status:

Press EDID button; the button will flash blue and the display will show the current EDID Status.

Step 1.

Press EDID button to exit.

Step 2.

To change the current EDID status:

Method 1

Press EDID button; the button will flash blue and the display will show the current EDID Status.

Step 1.

Press the Input (source) button (bottom row) to select EDID mode.

Step 2.

Repeatedly depressing the Source 1 button will cycle up thru the options.

Repeatedly depressing the Source 2 button will cycle down thru the options.

The options are sequential and require repeated depressing of the button to cycle thru the options.

Options are:

Auto

1080p/2CH

1080p/5.1

1080p/7.1

1080i/2CH

720p/2CH

All Outputs will be set to the highest common resolution of all connected display devices.

Example for single source:

Destination> press #1 and then Source> press #1

Destination device #1 will set to the highest common resolution of source #1

Example for multiple sources

Destination device #1, #2, #3 will be set to the highest common resolution available and source device #1 will

output this same resolution.

Press the DEMO button to set EDID mode.

Step 3.

Method 2

In some cases, the display screen maybe dark, or no picture, distorted color or without sound. This is caused by import ability of

the EDID.

Some causes of this are:

1. Destination resolution 480p EDID. Source is 1080p or 720p

2. Destination resolution 1080p EDID. Source is 480p, 720p or 1080p

3. Either Source or destination has no EDID code, or firmware is older version; in this event, you can manually link source EDID

to destination EDID.

Press EDID button; the button will flash blue and the display will show the current EDID Status.

Step 1.

Press Output button 1 thru 8 destination row on the affected display.

Step 2.

Press DEMO to save setting and return switcher to regular operating mode.

Step 3.

EDID FUNCTION

Display = Auto <Default>

Display: 1080p-2ch

Display: 1080p-51

Display: 1080p-71

Display: 1080i-2ch

Display :720p-2ch

The switcher will return to operation mode.