AEG ABK6821HAF 사용자 설명서 - 페이지 11
{카테고리_이름} AEG ABK6821HAF에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG ABK6821HAF 16 페이지.
페이지 인쇄
Problem
There is too much frost and
ice.
The compressor does not
start immediately after
pressing the FROSTMATIC,
or after changing the tem-
perature.
Water flows into the refriger-
ator.
Temperature cannot be set.
The temperature in the ap-
pliance is too low/too high.
Possible cause
The door is not closed cor-
rectly or the gasket is de-
formed/dirty.
The water drainage plug is
not correctly positioned.
Food products are not wrap-
ped properly.
Temperature is set incorrect-
ly.
This is normal, no error has
occurred.
The water outlet is clogged.
Food products prevent that
water flows into the water
collector.
The FROSTMATIC function
is switched on.
The temperature regulator is
not set correctly.
The door is not closed cor-
rectly.
The food products' tempera-
ture is too high.
Many food products are
stored at the same time.
The thickness of the frost is
greater than 4-5 mm.
The door has been opened
often.
The FROSTMATIC function
is switched on.
ENGLISH
Solution
Refer to "Closing the door".
Position the water drainage
plug in the correct way.
Wrap the food products bet-
ter.
Refer to "Operation" chap-
ter.
The compressor starts after a
period of time.
Clean the water outlet.
Make sure that food prod-
ucts do not touch the rear
plate.
Switch off FROSTMATIC
manually, or wait until the
function resets automatically
to set the temperature. Refer
to "FROSTMATIC function"
Set a higher/lower tempera-
ture.
Refer to "Closing the door".
Let the food products tem-
perature decrease to room
temperature before storage.
Store less food products at
the same time.
Defrost the appliance.
Open the door only if neces-
sary.
Refer to "FROSTMATIC
function".
11