AEG AGB625F7NW 사용자 설명서 - 페이지 15
{카테고리_이름} AEG AGB625F7NW에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG AGB625F7NW 20 페이지.
페이지 인쇄Problem
The compressor does not
start immediately after
pressing the "FROSTMAT‐
IC", or after changing the
temperature.
Door is misaligned or inter‐
feres with ventilation grill.
Door does not open easily.
Side panels of the appliance
are warm.
The lamp does not work.
There is too much frost and
ice.
Possible cause
Food products placed in the
appliance were too warm.
The door is not closed cor‐
rectly.
The FROSTMATIC function
is switched on.
The compressor starts after
a period of time.
The appliance is not level‐
led.
You attempted to re-open
the door immediately after
closing.
This is a normal state
caused by operation of the
heat exchanger.
The lamp is in stand-by
mode.
The lamp is defective.
The door is not closed cor‐
rectly.
The gasket is deformed or
dirty.
Food products are not wrap‐
ped properly.
Temperature is set incorrect‐
ly.
Appliance is fully loaded and
is set to the lowest tempera‐
ture.
Temperature set in the appli‐
ance is too low and the am‐
bient temperature is too
high.
ENGLISH
Solution
Allow food products to cool
to room temperature before
storing.
Refer to "Closing the door"
section.
Refer to "FROSTMATIC
function" section.
This is normal, no error has
occurred.
Refer to installation instruc‐
tions.
Wait a few seconds between
closing and re-opening of
the door.
Close and open the door.
Contact the nearest Author‐
ized Service Centre.
Refer to "Closing the door"
section.
Refer to "Closing the door"
section.
Wrap the food products bet‐
ter.
Refer to "Control Panel"
chapter.
Set a higher temperature.
Refer to "Control Panel"
chapter.
Set a higher temperature.
Refer to "Control Panel"
chapter.
15