AEG OKO-SANTO 2842-6 i 작동 및 설치 지침 - 페이지 19

{카테고리_이름} AEG OKO-SANTO 2842-6 i에 대한 작동 및 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG OKO-SANTO 2842-6 i 28 페이지. Integrating fridge freezer
AEG OKO-SANTO 2842-6 i에 대해서도 마찬가지입니다: 작동 및 설치 지침 (14 페이지)

페이지 인쇄

Installation

Electrical Connection

Any electrical work required to install this appliance should be carried

out by a qualified electrician or competent person.

WARNING Ð THIS APPLIANCE MUST BE EARTHED

The manufacturer declines any liability should these safety mea-

sures not be observed.

Before switching on, make sure the electricity supply voltage is the

same as that indicated on the appliance rating plate. The rating plate

is inside, on the left.

The appliance is supplied with a 13 amp plug fitted. In the event of

having to change the fuse in the plug supplied, a 13 amp ASTA appro-

ved (BS 1362) fuse must be used.

Important!

The wires in the mains lead are coloured in accordance with the fol-

lowing code:

Green and Yellow Earth

Blue Neutral

Brown Live

As the colours of the wires in the mains lead of this appliance may not

correspond with the coloured markings identifying the terminals in

your plug, proceed as follows:

The wire coloured green and yellow must be connected to the termi-

nal marked with the letter ÒEÓ or by the earth symbol or coloured green

and yellow.

The wire coloured blue must be connected to the terminal ÒNÓ or

coloured black.

The wire coloured brown must be connected to the terminal marked

ÒLÓ or coloured red.

Upon completion there must be no cut, or stray strands of wire pre-

sent and the cord clamp must be secure over the outer sheath.

Warning! A cut-off plug inserted into a 13 amp socket is a serious

safety (shock) hazard. Ensure that the cut-off plug is disposed of

safely.