AEG S53620CTXF 사용자 설명서 - 페이지 10

{카테고리_이름} AEG S53620CTXF에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG S53620CTXF 16 페이지.
AEG S53620CTXF에 대해서도 마찬가지입니다: 사용자 설명서 (44 페이지)

페이지 인쇄

www.aeg.com

Problem

The compressor does not

start immediately after

pressing the FROSTMATIC,

or after changing the tem-

perature.

Water flows inside the re-

frigerator.

Water flows on the floor.

Temperature cannot be set. The FROSTMATIC or

The temperature in the ap-

pliance is too low/too high.

If the advice does not lead

to the desired result, contact

the nearest Authorised

Service Centre.

6.2 Replacing the lamp

The appliance is equipped with a longlife

LED interior light.

7. INSTALLATION

WARNING!

Refer to Safety chapters.

Possible cause

This is normal, no error has

occurred.

The water outlet is clog-

ged.

Food products prevent that

water flows into the water

collector.

The melting water outlet is

not connected to the evap-

orative tray above the com-

pressor.

COOLMATIC function is

switched on.

The temperature regulator

is not set correctly.

The food products' temper-

ature is too high.

Many food products are

stored at the same time.

The FROSTMATIC function

is switched on.

Only service is allowed to replace the

lighting device. Contact your Authorised

Service Centre.

Solution

The compressor starts after a

period of time.

Clean the water outlet.

Make sure that food products

do not touch the rear plate.

Attach the melting water out-

let to the evaporative tray.

Switch off FROSTMATIC or

COOLMATIC manually, or wait

until the function resets auto-

matically to set the tempera-

ture. Refer to "FROSTMATIC

or COOLMATIC function".

Set a higher/lower tempera-

ture.

Let the food products temper-

ature decrease to room tem-

perature before storage.

Store less food products at the

same time.

Refer to "FROSTMATIC func-

tion".