AEG SANTO 75428 DT 사용자 설명서 - 페이지 11

{카테고리_이름} AEG SANTO 75428 DT에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG SANTO 75428 DT 46 페이지.

Electrical connection

Before initial start-up, refer to the appliance rating plate to ascertain if

supply voltage and current values correspond with those of the mains at the

installation location.

e.g.:

(i.e. 230 to 240 volts alternating current, 50 Hertz)

The rating plate is inside the appliance on the left.

A correctly installed, earthed socket is required for the electrical supply. The

supply must have a fuse rating of at least 10 Amps.

If the socket is not accessible once the appliance is built in, the electrical

installation must include suitable means of isolating the appliance from the

mains (e.g. fuse, cut-out, current trip or similar with a minimum contact

separation of 3 mm).

Attention: The mains connection cable may only be replaced by a skilled

electrician. Please contact your dealer or our customer service department

for repairs.

Prior to Initial Start–Up

• Please clean the appliance interior and all accessories prior to initial start-

up (see section: "Cleaning and Care").

230 ... 240 V

230 ... 240 V~

50 Hz

50 Hz or