AEG 2020 D 작동 및 설치 지침 - 페이지 14

{카테고리_이름} AEG 2020 D에 대한 작동 및 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG 2020 D 21 페이지. Cooker hood
AEG 2020 D에 대해서도 마찬가지입니다: 작동 및 설치 지침 (20 페이지)

Slide the chimney through the hole in the shelf

before fixing it to the canopy.

Top Shelf

The top shelf only requires drilling if the hood is to be

installed with the air outlet turned upwards.

Use the cardboard template provided to mark the

hole position on the shelf.

Using the hole 'B' as a reference point, drill the

shelf along the centre axis for the chimney to pass

through.

Installation in the recirculation mode:

The cooker hood is specified for installation in the

recirculation mode with the charcoal filter fitted.

Draw a vertical line on the wall from the centre of

the cooking appliance, using a spirit level and

marking pen. This is to ensure the correct vertical

alignment of the appliance.

Using the cardboard template provided mark the

hole position (1) on the wall 100mm either side

of the vertical line ensuring they are level and

that the distance between the lowest point of the

hood and the cooking appliance beneath meet

the clearance requirements quoted in the

paragraph titled 'Clearance Heights'.

Using the cardboard template mark the hole

positions (to be used for fixing the chimney)

30mm either side of the vertical line. The holes

must be drilled at a distance of (X) from the

horizontal line running through the centre of the

canopy fixing holes (1), which is calculated by

measuring the lenght of the chimney required for

the installation plus 15mm equal (Z).

Using a 8mm masonry bit, drill the holes for the

canopy and the fan assembly and insert the rawl

plugs provided ready for the fixing screws.

INSTALLING INSTRUCTIONS

S07_05

ø 8

100 100