AEG DD 8665 작동 및 설치 지침 - 페이지 19

{카테고리_이름} AEG DD 8665에 대한 작동 및 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG DD 8665 21 페이지. Aeg ventilation hood user manual
AEG DD 8665에 대해서도 마찬가지입니다: 작동 및 설치 지침 (21 페이지), 작동 및 설치 지침 (23 페이지), 작동 및 설치 지침 (21 페이지), 작동 및 설치 지침 (21 페이지), 작동 및 설치 지침 (21 페이지)

Mark the wall with a centre line, this will aid mounting procedure (1),

position the template so that the mid line printed on the template

matches with the centre line previously drawn, the lower side of the

template corresponds to the lower side of the hood once mounted

(2).

Drill two holes 0 8mm and fix the support bracket with two wall

plugs and screws (3). Hang the hood (4) and adjust its position (5-

6).

From the inside of the hood sign two points for definitive fixing (7).

Remove the hood (8) and drill two holes 0 8mm (9), fit two wall

plugs (10).

Drill two holes 0 8mm on the upper side close to the ceilling, fit two

wall plugs (11) (In case the hood is to be used in filter version,

mount the deflector F on the chimney support with four screws

2,9x6,5 (2 screws for hood model DD 8625-8821)) and fix the

chimney support G with two screws (12).

Hang the hood again (13) and fix it definitively with two screws (14).

Fit an exhausting pipe (15) to connect the outlet hole A of the hood

to the outside (Extractor hood) or to the deflector F (Filter version).

Make electrical connection (16).

Fix the chimney first up (17a) to the chimney support (17b), then

slide the lower section of the chimney down into the proper housing

on top of the hood (18).

Only for model DD 8625-8821: Fix the lower section to the hood

with two screws 3x9 mm (19).