Kohler BELAY K-156T-RCP 설치 지침 매뉴얼 - 페이지 4

{카테고리_이름} Kohler BELAY K-156T-RCP에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Kohler BELAY K-156T-RCP 23 페이지.

페이지 인쇄

1. Installation Instructions

PRODUCT REQUIREMENTS

A. Summary Of Key Requirements

Observe all local plumbing codes.

Install the bath to an adequately supported, level

subfloor.

· The bath is designed for alcove installation.

K-156T-LCP/RCP is designed for below-the-floor

drain installation. K-23769T-LCP/RCP is designed

for above-the-floor drain installation.

B. Plumbing Specifications

If using a rim-mounted bath faucet, flexible connections

between the valves and spout may be required.

Confirm adequate mounting, connection

specified faucet for your installation.

C. Product Inspection

Uncrate and inspect bath for damage. Leave all

materials in the crate during construction to prevent

damage.

NOTE: Damage occurred during transport or

installation shall not be covered by warranty.

D. New or Replacement Installation

Requirements

For replacement: Remove the old bath from the alcove,

and remove all old wall material and floor covering from

the area. Remove any old plumbing that does not

conform to the roughing-in requirements. Refer to the

roughing-in, and repair or replace the stud framing and

subfloor, as need. Measure and cut a channel in the

subfloor to accommodate the drain pipe and fittings.

Position the plumbing according to the roughing-in

dimensions. Cap the suppliers, and check for leaks.

For new installation: Refer to the roughing-in, and

construct the stud framing. Measure and cut a channel

in the subfloor to accommodate the drain pipe and

fittings. Position the plumbing according to the

roughing-in dimensions. Cap the suppliers, and check

for leaks.

1397340-T01-A

space

Water Pipe Location

Channel Depth

For K-156T-LCP/RCP only.

K-156T-LCP/RCP

K-23769T-LCP/RCP

Wall

Ground

-4-