Kohler Composed K-EX20257T-NWS3-CP 설치 지침 매뉴얼 - 페이지 2

{카테고리_이름} Kohler Composed K-EX20257T-NWS3-CP에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Kohler Composed K-EX20257T-NWS3-CP 14 페이지. Desk-mount sensor faucet

페이지 인쇄

注意事项

1. 一定要先彻底冲洗供水管以清除管道中的杂

质，使用水源为自来水或可供饮用水。

2．请勿将强力及冲击施于产品，以免造成故障，

引起漏水。

3．安装、清洁龙头时，切勿损伤感应窗口表面，

以免造成故障。

4．如果是安装新的洗面盆，可将水龙头和排水组

件先安装好到面盆上。

5. 对于直流龙头，安装时注意电池的正负极不能

装反，电池盒盖要拧紧，防止电池受潮。

6. 对于交流龙头，安装时务必按照说明书的要

求正确连接导线，龙头安装完毕后才可向电源盒

供电。

7. 一个交流电源盒最多可供一个感应龙头。

8. 修理面盆时，用黑色电工胶布粘住感应窗口。

9. 维修交流龙头时，必须断开交流电源并关闭

水源。

手伸到出水口下方感应范围内

（感应距离随面盆、周围的情况

而自动调节），水龙头出水。手

离，0.5～1秒后，水龙头自动止

水。

注意：

请勿将龙头安装在台面上，同

时搭配台上盆。

Notes:

1. Flush the water supply pipes thoroughly to remove debris.

Faucet is designed for tap water or potable water.

2. Do not strike the faucet with rough strength to avoid being

damaged.

3. Do not damage the surface of sensing window when

installing or cleaning the faucet.

4. For new installations, install the faucet and drain to the

lavatory before installing the lavatory.

5. As for DC type faucets, please pay special attention to

insert direction match of battery poles. Tighten the battery

cover completely to prevent its exposure to moisture.

6. As for AC type faucets, strictly follow indicated instructions

to perform electric connection. Only provide electric supply

to power box after the installation is completed.

7. One AC/DC transformer for max.one faucets.

8. Cover the sensing window with black tape when repairing

lavatories.

9. Turn off the electrical source and shut down water supply

before the faucets repaired.

OPERATION INSTRUCTIONS

Put your hand in the sensing -range, the faucet

should turn on. The faucet should turn off after

removal within 0.5~2 seconds. The sensing

distance will be adjusted automatically according

to the condition of the lavatory and surrounding

environment.

Note:

please do not install the faucet on the table

and match the washbasin

1495648-T2-A