Kohler EXHALE 77361T-E 설치 지침 - 페이지 2

{카테고리_이름} Kohler EXHALE 77361T-E에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Kohler EXHALE 77361T-E 2 페이지. Slide shower

페이지 인쇄
Kohler EXHALE 77361T-E 설치 지침
INSTALLATION
1
2
3
7
10
8
5
4
9
7
6
12
2
11
Drain notch
11
Drain
notch
12
1286380-AN2-A
How to Install the Slide Bar
Decide on a suitable position for the slide bar avoiding
buried cables and pipes in the wall.
Drill two holes at the proper height on the finished wall
according to the rough-in dimensions and should
match the anchors(1).
Put anchors into the holes. Install the upper and under
①
base(2) with screws(3) in the wall.
Place the bar(5) into the under slide bar body(6).
Install the screw(7), tighten them by hex wrench(8).
Slide the handshower holder(4) onto the bar. The
height of handshower holder can be adjusted by
pressing the pinch cock(9) and sliding up and down.
Adjust it to the proper position.
Tighten the screw(7) to secure upper slide bar
body(10) by hex wrench according to the rough-in
dimensions. Make sure the directions of the upper and
under slide bar body are consistent.
②
Slide the bracket escutcheons(11) onto the bases(2),
confirm the drain notch of the escutcheon is pointed
down. Install the whole slide bar onto the bases.
Tighten the screws(12) by hex wrench to secure the
slide bar.
③
15
17
CLEANING INSTRUCTIONS
All Finishes: Clean the finish with mild soap and warm water. Wipe entire surface completely dry with clean soft
cloth. Many cleaners may contain chemicals, such as ammonia, chlorine, toilet cleaner etc, which could adversely
affect the finish and are not recommended for cleaning.
Do not use abrasive cleaners or solvents on Kohler faucets and fittings.
2
1286380-AN2-A
How to Install the Connection Kit
13
Before installation, installer must provide G1/2" supply
fitting(13). Ensure it extend 12~20mm beyond the
16
finished wall.
Apply tape or thread sealant to G1/2" threads of the
supply fitting. Apply a ring of plumber putty or other
sealants around the underside of the connection
kit(16). Install the connection kit onto the supply fitting.
Adjust the connection kit and make sure the outlet(14)
14
and drain notch(15) of the escutcheon downwards.
Remove any excess putty.
How to Install the Handshower and Hose
Flush both water supplies for about one minute before
the handshower(18) is installed. Attach the
handshower to shower hose(17). NOTE: Don't over
18
tighten.
Connect another end of shower hose to the outlet(14)
of the connection.
Hang the handshower in the bracket(4).
How to Maintain the Handshower
Any debris or mineral build-up may cause the flow
stream to become distorted or reduce the flow rate.
To remove the debris or mineral build-up, run water
through the handshower, firmly press or rub your
finger back and forth across the rubber nozzles.
3