Kohler Clearflo K-7161 설치 및 관리 매뉴얼 - 페이지 16

{카테고리_이름} Kohler Clearflo K-7161에 대한 설치 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Kohler Clearflo K-7161 24 페이지. Bath drains
Kohler Clearflo K-7161에 대해서도 마찬가지입니다: 설치 지침 (4 페이지), 주택 소유자 매뉴얼 (21 페이지)

페이지 인쇄
Kohler Clearflo K-7161 설치 및 관리 매뉴얼
Ajuste el obturador
Gire la manija hacia la izquierda. La distancia entre el lado inferior del obturador
del desagüe y la superficie de la bañera debe ser 3/8" (1 cm).
Ajuste
Retire el obturador de la varilla roscada.
Gire la tuerca en la varilla roscada. Para subir el obturador, gire la tuerca hacia la
izquierda. Para bajar el obturador, gire la tuerca hacia la derecha.
Vuelva a instalar el obturador en la varilla roscada.
Verifique que la distancia entre el obturador del desagüe y la superficie de la
bañera sea 3/8" (1 cm).
8.
Check Lift Rod Operation
Lift Rod Assembly
Ensemble de tige de levage
Montaje del tirador
Adjusting Block
Bloc de réglage
Bloque de ajuste
Adjusting Rail
Rail réglable
Riel de ajuste
NOTE: If sufficient clearance cannot be obtained by adjusting the stopper, perform
the following procedure.
Remove the handle.
Remove the lift rod assembly from the overflow ell.
Loosen the screw from the adjusting block.
Slide the adjusting block on the adjusting rail. To increase clearance, slide the
adjusting block up. To decrease clearance, slide the adjusting block down.
Retighten the screw at the desired adjusting block height.
Reinsert the lift rod assembly into the overflow ell.
Reinstall the handle.
1101880-2-B
Screw/Vis/Tornillo
16
Kohler Co.