Kohler Command Pro CH1000 소유자 매뉴얼 - 페이지 12

{카테고리_이름} Kohler Command Pro CH1000에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Kohler Command Pro CH1000 21 페이지. Horizontal/vertical shaft
Kohler Command Pro CH1000에 대해서도 마찬가지입니다: 소유자 매뉴얼 (8 페이지)

페이지 인쇄

Paper Element

Figure 21. Removing Elements.

3. After the paper element is removed, check the

condition of the inner element. It should be

replaced whenever it appears dirty, typically

every other time the paper element is replaced or

every 600 hours. Clean the area around the base

of the inner element before removing it, so dirt

does not get into the engine.

4. Do not wash the paper element and inner

element or use compressed air, this will damage

the elements. Replace dirty, bent or damaged

elements with new genuine Kohler elements as

required. Handle the new elements carefully; do

not use if the sealing surfaces are bent or

damaged.

5. Check all parts for wear, cracks, or damage, and

make sure ejector area is clean. See Figure 22.

Replace any damaged components.

Ejector

Area

Figure 22. Ejector Area.

6. Install the new inner element, Kohler Part No.

25 083 04-S followed by the paper element, Part

No. 25 083 01-S. Slide each fully into place in the

air cleaner housing.

7. Reinstall the end caps and secure with the

retaining clips. See Figure 19.

Flat Air Cleaner

The flat air cleaner has a replaceable, high density

paper air cleaner element. Some engines are also

equipped with an oiled, foam precleaner which

surrounds the paper element. See Figure 23.

Inner

Element

Element Latch

Figure 23. Flat Air Cleaner.

Service Precleaner

If so equipped, wash and reoil the precleaner every 25

hours of operation (more often under extremely dusty

or dirty conditions).

1. Loosen the cover retaining knobs and remove the

cover.

2. Remove the precleaner from the paper element.

3. Wash the precleaner in warm water with

detergent. Rinse the precleaner thoroughly until

all traces of detergent are eliminated. Squeeze out

excess water (do not wring). Allow the precleaner

to air dry.

4. Saturate the precleaner with new engine oil.

Squeeze out all excess oil.

5. Reinstall the precleaner over the paper element.

6. Reinstall the air cleaner cover. Secure cover with

the cover retaining knobs.

7. When precleaner replacement is necessary, order

genuine Kohler parts.

Cover Knobs

Air Cleaner

Cover

Precleaner

Element