Kohler K582 소유자 매뉴얼 - 페이지 7

{카테고리_이름} Kohler K582에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Kohler K582 17 페이지. Four-cycle, twin cylinder, air-cooled engine

페이지 인쇄
Kohler K582 소유자 매뉴얼
ODeratina
Cooling
NOTE:
Angle of Operation
This engine will operate continuously
at angles up to
35' in any direction.
Check oil level to assure
crankcase
oil level is at the "F" mark.
If debris builds
up on the grass screen or
other cooling air intake areas, stop the engine
immediately
and clean. Operating
the engine
with blocked or dirty air intake and cooling
areas can cause extensive
damage due to
overheating.
Refer to the operating
instructions
of the equipment
this engine powers. Because of equipment
design or
application,
there may be more stringent
restrictions
regarding the angle of operation.
NOTE:
Do not operate this engine continuously
at
angles exceeding
35" in any direction.
Engine damage could result from insufficient
lubrication.
A
Engine
WARNING:
Hot Parts!
components can get extremely hot from
l
operation. To prevent severe burns, do not touch
these areas while the engine is running-or
immediately
after it is turned off. Never operate the
engine with heat shields or guards removed.
Engine Speed
NOTE:
Do not tamper with the governor setting to
increase the maximum engine speed.
Overspeed
is hazardous
and will void the
engine warranty.
Maintenance Instructions
A
WARNING:
Accidental
Starts!
Before servicing the engine or equipment,
always disconnect the spark plug lead to prevent the engine from
starting accidentally
Ground the lead to prevent sparks that could cause fires. Make sure the equipment
is in
neutral.
Maintenance
Schedule
These required maintenance
procedures
should be performed at the frequency
stated in the table. They should
also be included as part of any seasonal tune-up.
Frequency
1 Maintenance
Required
Daily or Before
,
Starting
Engine
Every 25 Hours
Every 50 Hours
Every 100 Hours
Annually
or
Every 500 Hours
0 Fill fuel tank.
0 Check oil level.
l
Check air cleaner for dirty', loose, or damaged parts.
6 Check air intake and cooling areas, clean as necessary'.
0 Service precleaner
element'.
I
1
0 Change oil.
l
Remove cooling shrouds and clean cooling areas.
0 Service air cleaner element!
0 Change oil filter.
0 Check spark plug condition and gap.
0 Have bendix starter drive serviced*.
l
Have breaker points checked2.
0 Have ignition timing checked2.
0 Have valve and tappet clearance checked2.
0 Have cylinder heads serviced213.
IPerform these maintenance
procedures
more frequently under extremely dusty, dirfy conditions.
2Have a Kohler Engine Service Dealer perform this service.
3250 hours when leaded gasoline is used.
7