Kohler KD 500 워크샵 매뉴얼 - 페이지 35

{카테고리_이름} Kohler KD 500에 대한 워크샵 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Kohler KD 500 44 페이지. 51267

Workshop Manual KD500 _ cod. ED0053029390 - 1° ed_rev. 00

Counter-shaft float (optional):

Place a calibrated bar on a level with the timing system cover

retention surface and use a thickness gauge to check the

distance between the stop surface and bar (fig. 64). The

measured value must be between:

0,10 ÷ 0,25 mm

Spread liquid seal of the AREXON D 0036 MOTORSIL type on

the retention surface of the timing system cover (fig.65).

Place the cover on the casing.

Insert the cover fixing screws, making sure that the five shorter

ones (40 mm) are mounted in the top part of the cover. Tighten

to the following torque value:

2,7 ÷ 2,8 kgm (26,5 ÷ 27,5 Nm)

1. Immerse the retention ring in oil for about 10 minutes.

2. Clean the housing and insert the ring with a plug, exercising

an even pressure all over the surface (fig.66).

Block the flywheel (fig. 67) and torque the nut to value:

18 ÷ 20 kgm (176,5 ÷ 196,1 Nm)

Engine assembly

- 35 -