Kohler SV810-840 소유자 매뉴얼 - 페이지 9

{카테고리_이름} Kohler SV810-840에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Kohler SV810-840 20 페이지. Vertical crankshaft
Kohler SV810-840에 대해서도 마찬가지입니다: 소유자 매뉴얼 (21 페이지), 소유자 매뉴얼 (21 페이지)

페이지 인쇄

Change the oil and oil filter as follows.

1. The drain plug is located on the starter side of the

oil pan. See Figure 8. Clean the area around the

oil drain plug and the oil fill cap/dipstick.

2. Remove the drain plug and the oil fill cap/

dipstick.

3. Allow the oil to drain and then reinstall the drain

plug. Tighten 13.6 N.m (10 ft. lb.).

4. Remove the old filter and wipe off the filter

adapter

with a clean cloth.

Place a new replacement

filter in a shallow pan

with the open end up. Pour new oil, of the proper

type, in through

the threaded

center hole. Stop

pouring

when the oil reaches the bottom of the

threads. Allow a minute or two for the oil to be

absorbed

by the filter material.

6. Apply a thin film of clean oil to the rubber gasket

on the new oil filter.

Install the new oil filter to the filter adapter. Hand

tighten the filter until the rubber

gasket contacts

tile adapter,

then tighten the filter an additional

3/4-1 turn.

8. Fill the engine with the proper

oil to tile FULL or

"F" mark on the dipstick. Always check the oil

level with the dipstick

before adding more oil.

9. Reinstall the oil fill cap/dipstick

and tighten

securely.

10. Start the engine and check for oil leaks. Recheck

oil level before placing the engine into service.

Stop the engine, correct any leaks, and allow a

minute for the oil to drain down, then recheck the

level on the dipstick.

NOTE:

To prevent

extensive engine wear or damage,

always maintain

the proper

oil level in the

crankcase.

Never operate the engine with

tile oil level above tile "F" or FULL mark, or

below the "L" or LOW mark on the dipstick.

Service Precleaner

and Air Cleaner

Element

These engines

are equipped

with a replaceable,

high

density paper air cleaner element. Some engines are

also equipped

with an oiled, foam precleaner

which

surrounds

the paper element.

See Figures 10 and

11. Two different

capacity air cleaner systems are

available.

Check the air cleaner daily or before starting

the

engine.

Check for a buildup

of dirt and debris around

the air cleaner system. Keep this area clean. Also check

for loose or damaged

components.

Replace all bent or

damaged

air cleaner components.

NOTE:

Operating

the engine with loose or damaged

air cleaner components

could allow unfiltered

air into the engine causing premature

wear

and failure.

Precleaner (Some Models'

Figure 10. Courage Air Cleaner System.

Element (Taller)

Latch

Door

Figure 11. Courage

PRO Air Cleaner System.

Figure 12. Unhooking

Latch (Courage).