Acapella Audio Arts Duke 사용 설명서 - 페이지 3

{카테고리_이름} Acapella Audio Arts Duke에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Acapella Audio Arts Duke 9 페이지.

Set up and Installation

Operating voltage

Make sure that the visible label of King and Queen near the power connector (A), indicating the

factory-set AC mains operation, corresponds to the nominal AC operating voltage for your location.

If the indicated voltage is incorrect relative to that supplied in your area, see your dealer.

Connections and cables

Connect the loudspeakers "Duke" to the amplifier "King", using the supplied XLR-cables. Connect

one of the two pairs of outputs (C) of the CD-player/Tuner combination "Queen" to the central pair

of inputs (B) of the amplifier "King", using the RCA-type cable (Cinch) which is supplied as well.

Please note that the assignment of the sides must be correct: Red = right channel = lower single-

ended input (Cinch).

Connect Queen's antenna input (E) to the antenna wall socket using an antenna cable (not supplied).

After transport or storage, considerable differences between the temperature of both the devices and

the listening room can occur. Allow the devices time to acclimatize to room temperature. Plug the

power cord in to the power connector (A) of King and Queen and then plug it into the wall outlets.

Programming the tuner/Reset

Queen's tuner has a storage capacity of 79 slots. After previous "reset", which will be released by

pressing the button (B) on the rear panel with the tip of a pencil, they will be loaded automatically

with well receivable radio stations. The sort will be made in chronological order from memory 20 on

within the range of reception. The first 19 slots will particularly be assigned to enable you to store

your favourite radio stations manually in the order you desire.

After the automatic programming you can load the station memories as follows: Tune in your

selected station. Press the external buttons of Queen at the same time now. The LED indicator jumps

to a free memory You can change this proposal pressing one of the external buttons. When the

desired position has been reached, confirm this pressing the center button. To facilitate further

change of programming, the indicator jumps back to the starting point again.

For more information on the operation see the following pages.