Acapella Audio Arts Duke 사용 설명서 - 페이지 5

{카테고리_이름} Acapella Audio Arts Duke에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Acapella Audio Arts Duke 9 페이지.

Attention: If King does not accept any operating function, a reset of the control of the microprocessor could be

necessary. Disconnect the unit from the power source (Reset) and plug it in again after approx. 30 seconds.

Whenever the power cord is connected to the outlets, an energy-saving mode is activated to maintain the high quality

of King. This ensures best performance after start-up of the system and increases the longevity of the unit.

King

Buttons

Press the bottom !

• Left

more low

• Center

on, input two selected/off

• Right

louder

LED´s

lower rank, three LED's, input display

• Left

input 1 active

• Center

input 2 active

• Right

input 3 active

• Upper series, five tri-colored LED's, volume display,

indicating as a running light, beginning with green = low

volume across yellow = medium to red = loud.

• When the muting button on the remote control is

activated, the indicator LED of the selected volume will

blink.

Rear panel

• Socket A = power connector equipped with a locking

clamp and voltage selector. Please make sure that the

preset voltage is correct. If the component shows no

function, check the fuse. A spare fuse (2A slow blow) is

located in the clamp.

• Socket B = input connectors, from the left side to

the right 1-2-3.

Left channel = white above, right channel = red below.

• Socket C = outputs for Duke's. Connect them with the

supplied special cable (XLR). Looking from the front

panel right side = right Duke, left side = left Duke.

• Socket D = Connection of remote control synchroncable.

(Please connect them with the supplied cable to socket „D"

at QUEEN)