A.H. Systems SAS-512F-4 운영 매뉴얼 - 페이지 8

{카테고리_이름} A.H. Systems SAS-512F-4에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. A.H. Systems SAS-512F-4 14 페이지. Log periodic antenna

A.H. Systems SAS-512F-4 Log Periodic Antenna

OPERATING INSTRUCTIONS

Once the antenna is mounted to a mast or tripod, connect an N-type coaxial

cable from the antenna to a receiver or RF generator. The cable should be

matched to 50 ohms, relatively low loss and adequately shielded against

leakage such as RG-214/U or better. For certain applications where an

increased dynamic range is required, an optional preamplifier (PAM-0204) may

be used to increase the total system sensitivity.

The Log Periodic Antenna is in the horizontal polarization when the antenna

elements are parallel to the ground, and vertical polarization when the elements

are perpendicular to the ground.

To minimize impedance mismatch errors, it is recommended that high-quality

in-line attenuators be used to reduce reflections. Connect the attenuator at the

antenna end of the transmitting cable, or when receiving connect the attenuator

at the measuring instrument or preamplifier input.

Dress the cables straight back from the antenna connector at least 1 meter

before being dressed vertically down to the ground plane. Signal cables that

are dressed orthogonal to the antenna elements will have minimal coupling to

the antenna field, but the cable shields may carry external currents caused by

impedance imperfections. Also, portions of the cables that are not straight down

or straight back will couple to the antenna fields.

 A.H. Systems inc. – May 2014

REV C