Aqua Flo A Series 소유자 매뉴얼 - 페이지 5

{카테고리_이름} Aqua Flo A Series에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aqua Flo A Series 8 페이지. Aqua flo "a" series & "lea" series pumps owner's manual

ASSEMBLY INSTRUCTIONS FOR MOUNTING

LIQUID END TO MOTOR

STEP 1

Remove pump and motor from their boxes and check for any possible shipping

damage.

STEP 2

Place motor vertically with shaft end up, being careful not to damage motor end

bell. Remove shaft key on motor if installed.

STEP 3

Install liquid end to motor by placing the pump shaft onto the motor shaft and

aligning the pump shaft set screws with the motor shaft keyway. Align pump

bracket holes with threaded holes on motor and install four 3/8"-16 hexbolts and

tighten with 9/16" wrench.

STEP 4

Place assembled pump in its normal position, on the pump base. To adjust

impeller, place screwdriver on the pump shaft as shown, and gently pry pump

shaft towards motor .015 inches and tighten one set screw with 1/8" Allen

wrench. Rotate shaft to check if impeller is clear. If impeller is clear, tighten all

set screws firmly. If impeller is not clear, loosen set screw and adjust impeller

further until it rotates freely.

(See illustration above)

STEP 5

The pump is now ready for installation.