Aqua glider ZS30 사용자 설명서 - 페이지 10

{카테고리_이름} Aqua glider ZS30에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Aqua glider ZS30 11 페이지. Motorized inflatable ride on

6. Remove any blockage.

7. Replace drive pin, propeller and the washer, and

reattach propeller nut.

8. Replace rear grille.

Repairing the Inflatable

A repair kit is included in case the inflatable is

accidentally punctured, to repair:

1. Locate the puncture - this can be done by inflating the

inflatable and looking for air bubbles.

2. Deflate the inflatable and make sure it is completely dry.

3. Clean punctured area and dry the area.

4. Using inflatable repair kit apply glue around

punctured area.

5. Use repair PVC sheet, cut so it is 5mm bigger around

the punctured area.

6. Stick the repair sheet on top of the punctured area.

7. Let it dry for 2 hours.

8. Inflate the inflatable and check there is no air leakage

before use.

Maintaining Battery Door Seal

Always keep the Battery Door Seal clean and well

lubricated with silicone grease which can be purchased

from your local hardware store.

If the Aqua Glider does not work:

1. Check the battery is fully charged, if in doubt of

battery state, recharge the battery until charger

indicates full charged.

2. Make sure the rechargeable battery connector is

connected.

3. Make sure the Master Switch is in the 'On' position.

4. Make sure the battery compartment is dry.

5. Make sure the propeller is not blocked.