Aqua Laser Delta Sweeper 815.564 사용 설명서 - 페이지 5
{카테고리_이름} Aqua Laser Delta Sweeper 815.564에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Aqua Laser Delta Sweeper 815.564 11 페이지.
To assemble the Aqua Laser Delta Sweeper
Remove the Aqua Laser Delta Sweeper and its components from the box.
IMPORTANT: properly dispose of the plastic bubble wrapping. Keep away from babies
and children.
Step 1. Screw the three pole sections until secure.
Step 2. Align the arrow on the bottom end of the pole with the arrow on the top end of
the pole base. Now with your thumb and pointer finger, simultaneously depress the
two buttons on either side of the plastic connector at the top of the pole base and, with
your other hand, slide the pole all the way down until it locks into place.
Charging the battery
Step 1. Plug the battery charger into a standard electrical outlet as below:
UL/cUL – 120V AC 60Hz
TUV/UK – 220-240V AC 50/60Hz
Step 2. Align the arrow on the rechargeable battery with the arrow on the battery charger. Then
insert the rechargeable battery down into the battery charger. NOTE: red light on the front of the
battery charger should turn on to indicate that the battery is charging.
IMPORTANT: for initial battery charge, let battery charge for at least 8 full hours. When
recharging, charge time will vary dependent upon the amount of power that is left in the battery
after its last use. Recommended recharging time for the battery after completely depleting it is 6-
8 hours. Battery may be left in charger for extended periods of time but do not exceed 24
consecutive hours. Doing so may lead to shortened overall battery life. It is not necessary to wait
until battery power is fully depleted before recharging.
Using the Aqua Laser Delta Sweeper
Step 1. Make sure the Aqua Laser Delta Sweeper is turned off. The on/off
switch is located on the front of the battery compartment.
Step 2. Make sure the dirt tray is empty (see following directions on emptying
the dirt tray).
Step 3. Insert the rechargeable battery down into the battery compartment
located on the front of the pole until it locks into place.
Step 4. Turn the Aqua Laser Delta Sweeper on to begin cleaning.
Step 5. When you are done cleaning, turn the Aqua Laser Delta Sweeper off. Remove the dirt tray and empty the
dirt & debris into a garbage receptacle. Recharge the battery if necessary.
Components
1. Handle
2. Heavy duty aluminum pole
3. Rechargeable 7.2V battery
4. Battery compartment
5. On/Off switch
6. Pole base
7. Tinted outer body frame
8. Base
9. Outer body frame lock clips
10. Dirt tray lock clips
11. Dirt tray
12. Rotating cleaning brushes
13. Battery charger
14. Brush cleaning tool & storage cover