Aqua light EasyClear UVC-18W 매뉴얼

{카테고리_이름} Aqua light EasyClear UVC-18W에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aqua light EasyClear UVC-18W 2 페이지. Clarifier

Aqua Light EasyClear UVc CLARIFIER

MANUAL for

UVC-18W, UVC-36W, UVC-55W

Our UV clarifiers are carefully inspected and tested to ensure both safety and operating performance.

However, failure to follow the instructions and warnings in the manual may result in clarifier damage

and/or serious injury. Be sure to read and save this manual for future reference.

WARNING:

The unit is designed for indoor use only. The supply cable of this clarifier cannot be replaced; if the

cable is damaged, the clarifier should be discarded. The installation must conform to the regulations

of the local electrical authority. Don't use the supply cable to lift the clarifier as this may cause

damage.

IMPORTANT-SAFETY WARNING

●Always disconnect all appliances from the electrical supply before putting your hands in the water

whilst the equipment is being installed, repaired, maintained or handled.

●The use of gloves and eye protection is recommended when installing or maintaining the clear

glass tube inside the clarifier.

●Do not run the clarifier dry or with a blocked inlet.

●The clarifier unit is weatherproof but not waterproof and must not be submerged in water.

Therefore, position the unit at least 2 m away from the edge of the pond to prevent the clarifier being

accidentally dropped into the water.

●Exposure to Ultra Violet (UV) radiation can cause damage to eyes and skin. Never look at the lamp

whilst switched on. A blue glow will be visible at the hose tail when the UV lamp is operating.

●To protect from frost the clarifier should be taken indoors during winter months when algae growth

stops. Clean and dry the unit and store in a dry place.

●Young children should always be supervised when near the water.

INSTALLATION

●The water must be pumped through the unit and not gravity fed.

●The unit must be installed horizontally on a solid surface by screwing the securing plates on the

mounting surface.

CONNECTING TO THE WATER SUPPLY