AVPro Edge AC-EX70-UHD-KIT 사용자 설명서 - 페이지 6

{카테고리_이름} AVPro Edge AC-EX70-UHD-KIT에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AVPro Edge AC-EX70-UHD-KIT 19 페이지. Ultra slim 4k hdmi via hdbaset 70 meter extender
AVPro Edge AC-EX70-UHD-KIT에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (4 페이지)

페이지 인쇄

If the BLUE HDMI SIGNAL LIGHT is flashing, check the following:

· The source. Plug it directly into the display to be sure it's functioning properly.

· Try a longer HDMI cable. Some HDMI cables do not sync well at shorter lengths, a 2 meter

minimum is recommended per HDMI Specifications.

· Set the EDID to state #1 (See Page[s] 12).

· Contact AVProEdge if these suggestions do not work.

STATUS - On front by HDMI Port: (Blue) This indicator shows that the HDMI

source is connected. The states are:

· Light Is On (Solid) = Sync w/ HDMI source is correct and solid.

· Light Is Flashing = The light flashes during the sync process. If it is flashing continuously, a

picture may not be present.

If the BLUE HDMI SIGNAL LIGHT is flashing, check the following:

· The source. Plug it directly into the display to be sure it's functioning properly.

· Try a longer HDMI cable. Some HDMI cables do not sync well at shorter lengths, a 2 meter

minimum is recommended per HDMI Specifications.

· Set the EDID to state #1 (See Page[s] 11).

· Contact AVProEdge if these suggestions do not work.

LINK above the RJ45 (HDBaseT) Port:

HDBaseT link between the Tx and Rx is intact. This light should ALWAYS be solid. If

this light is flashing or not present attempt the following:

· Check the length. The maximum distances are 40m (131ft) on 4K and 70m

(230ft) on 1080P.

· Remove any coils of cable and make sure that there is not excess cabling.

· Bypass all patch panels and punch-down blocks.

· Re-terminate connectors. Sometimes, even if a cable tester indicates the run is valid,

something may be slightly off.

· Contact AVProEdge if these suggestions do not work.

(Green)

This indicator shows that the