AVPro Edge AC-CXWP-USBC-100KIT 빠른 시작 매뉴얼 - 페이지 4

{카테고리_이름} AVPro Edge AC-CXWP-USBC-100KIT에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AVPro Edge AC-CXWP-USBC-100KIT 4 페이지. Wall plate transmitters

When using projectors RGB edid setting is recommended.

EDID can be managed using all wall-plate transmitters (VGA, HDMO, MDP, USB-C) and the EX100-

UHD-R3 receiver.

Copying EDID From Output:

With 70-Kits:

•

Connect category to TX/RX, HDMI to Display, and both RX and Display are powered

•

Turn dial to F on wall plate

With 100-Kits:

•

Connect category to TX/RX, HDMI to Display, and both RX and Display have power

•

Turn dial to F on RX

Troubleshooting

Having problems? Here are some general troubleshooting tips that may help:

(We recomend every integrator have the fox & hound troubleshooting kit. That way you have a

definitive answer when having problems with HDMI)

1. Try different HDMI cables. A defective HDMI cable can bring the entire system down.

2. If using short HDMI cables (.5m, 1m) try a longer cable. Some short HDMI cables do not sync

well.

3. Ensure you have the correct EDID settings selected.

4. Re-terminate the Category cable (even if a cable tester indicates that the cable is passing

signal).

5. Avoid RJ45EZ connectors

6. Check the Category cable length. It may be too long.

7. Remove any excess Category cable and be sure that it is not twisted or damaged.

8. If you are still having issues after troubleshooting, feel free to contact our Tech Support

department.

Have a question or need assistance?

Don't hesitate to contact us!

SUPPORT: +1 605-274-6055

USA TOLL FREE: 877-886-5112