AVPro Edge AC-MXNET-10G-SW12C 빠른 시작 매뉴얼 - 페이지 7

{카테고리_이름} AVPro Edge AC-MXNET-10G-SW12C에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AVPro Edge AC-MXNET-10G-SW12C 8 페이지. The mxnet 10g sdvoe ecosystem

Auto-Matrix

- SWITCHING

From here, users can switch between sources and displays, just like with an HDMI matrix switcher.

The sources are located on the left, and the displays are on the right. Simply click on a source,

then click the display it is to be viewed on. Matrix presets can also be saved and recalled on this

page for faster switching.

Troubleshooting

Transceiver or CBox not powering on:

network switch and check the LED indicator lights for each device connection. If only one device isn't

getting power, verify the connection to the network switch is correct (see examples below).

Verify Connections (device not getting power, video signal dropouts, Mentor shows device with poor connection, etc.):

Check that all cables are properly connected and not tightly bundled together or exceeding their bend

radius.

•

For Category cabling, re-terminate using standard RJ-45 connectors. Avoid using push-through or

"EZ" type ends, as these have exposed copper wiring at the tips that can damage or bend the pins

inside the ports.

•

For optical fiber cabling, try re-terminating fiber connection ends to eliminate potential issues.

•

Ensure the SFP+ modules are specifically designed to output 10Gb/s and are properly seated

within the SFP+ port on both the network switch and MXNet 10G device.

•

Generally speaking, the higher the video resolution and the longer the cable run, the better the

cabling should be. For most copper installations, Cat6a (or better) is recommended with MXNet.

If all devices are not getting power, verify the power connection on the

Page 7 of 8

MXNET 10G SDVoE

Quick Start Guide