Aqua Pulse Spas Coral Classic Spa 사용자 설명서 - 페이지 5

{카테고리_이름} Aqua Pulse Spas Coral Classic Spa에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Aqua Pulse Spas Coral Classic Spa 15 페이지.

ELECTRICAL SAFETY

Do not place your spa within 3 metres of overhead power lines.

NEVER CONNECT POWER TO THE SPA USING AN EXTENSION LEAD.

The use of an extension lead will void your spas warranty.

You will need a suitable electrical supply to run the spa.

The Coral Classic Spa requires a 10Amp Residual Current Device Protected Dedicated Power Connection. Your

Licenced Electrical Contractor can hardwire the spa straight to the meter box in your house or they can install a

10Amp residual current device protected dedicated single power plug.

It is the responsibility of your Licenced Electrical Contractor to ensure the Residual Current Devise is installed at

the correct mA required by the law.

When appointing an electrician to prepare your spas electrics check that they are suitably qualified and licenced to

do so. Do not attempt to install the spas electrics yourself if you are not a fully Licenced Electrical Contractor.

If your spa is being hardwired, we recommend you install a Rotary Isolation Switch so that the spa can be isolated

from the power supply in an emergency or for service work. This is simply a rotary on/off switch but should be

sited more than 2 metres away from the spa so that users cannot be in the spa whilst operating the switch.

3 Pin Plug

If you have chosen to hardwire the spa your Licenced Electrical Contractor will locate the electrical

connection point here, unscrew and remove the cabinet panels directly underneath the spas touch pad.

While your electrician is on site make sure all the pumps are running before they leave site

Rotary Isolation Switch