Aqua Select 832406SC 매뉴얼 - 페이지 5

{카테고리_이름} Aqua Select 832406SC에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aqua Select 832406SC 8 페이지. Heavy duty resin in-pool ladders with entrapment barrier

페이지 인쇄

• Center locking cap (832402LC) over opening on

side of handrail where platform was just attached.

Using a rubber mallet or a hammer and a small

piece of wood, tap on cap until the cap is flush

with the handrail

• Repeat for each of the remaining (3) locking caps.

• Coat the tops of the legs with lubricant and attach

handrails by pushing them down over the legs.

Secure with (4) #10 1-1/4" screws through each of

the pre-marked openings.

STEP 5

FILL LEGS WITH SAND

USING A FUNNEL

• Using a funnel fill both legs with sand.

Use approximately 20 Lbs. of sand in each leg.

STEP 6

• Put ladder aside for now and install handrails

(AC HANDRAIL) onto platform (AC PLATFORM).

• Lay one handrail on flat surface and push the

connected dowels of the platform into the openings

on the handrail until fully seated. Make sure treads

of platform are facing upward.

• Before attaching second handrail, make sure that

the longer part of the handrail is facing in the same

direction on both handrails. Repeat above for

installation of second handrail.