HDD Protection
Table 7. — Boot
Boot List Option
Secure Boot
Legacy Option ROMs
Boot Option Priorities
Table 8. — Exit
Save Changes and Reset
System Setup overview
System Setup allows you to:
•
Change the system configuration information after you add, change, or remove any hardware in your computer.
•
Set or change a user-selectable option such as the user password.
•
Read the current amount of memory or set the type of hard drive installed.
Before you use System Setup, it is recommended that you write down the System Setup screen information for future reference.
CAUTION: Unless you are an expert computer user, do not change the settings for this program. Certain changes can
cause your computer to work incorrectly.
Accessing System Setup
1.
Turn on (or restart) your computer.
2.
After the white Dell logo appears, press F2 or F12 immediately.
The System Setup page is displayed.
NOTE: If you wait too long and the operating system logo appears, wait until you see the desktop. Then, shut down
or restart your computer and try again.
24
Default: Disabled
Allows to modify the HDD protection feature.
Default: Disabled
Displays the boot modes
Default: UEFI
File Browser Add Boot Option and File Browser Del Boot Option
are actiavted
Allows you to enable or disable the Secure Boot control.
Default: Enabled
Allows you to load the legacy option ROMs.
Default: Disabled
Enables you to change the boot option priorities.
Allows to save or rest the changes made to the system setup.
1.
Allows you to discard the changes made to the system
setup.
2.
Allows you to restore the system setup options to default.
3.
Allows you to discard the changes made to the system
setup.
4.
Allows you to save the changes made to the system setup.
페이지 인쇄