Dell E04B 참조 매뉴얼 - 페이지 13

{카테고리_이름} Dell E04B에 대한 참조 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell E04B 29 페이지. Bios and uefi

View NVMe settings

To view the NVMe Settings screen, perform the following steps:

Steps

1. Turn on, or restart your system.

2. Press F2 immediately after you see the following message:

F2 = System Setup

NOTE:

If your operating system begins to load before you press F2, wait for the system to finish booting, and then

restart your system and try again.

3. On the System Setup Main Menu screen, click System BIOS.

4. On the System BIOS screen, click NVMe Settings.

NVMe Settings details

About this task

The NVMe Settings screen details are explained as follows:

Option

Description

NVMe Mode

Enables you to set the NVMe mode. This option is set to Non RAID by default.

Boot Settings

You can use the Boot Settings screen to set the boot mode to either BIOS or UEFI. It also enables you to specify the boot

order.

● BIOS: The BIOS Boot Mode is the legacy boot mode. It is maintained for backward compatibility.

● UEFI: The Unified Extensible Firmware Interface (UEFI) is a new interface between operating systems and platform

firmware. The interface consists of data tables with platform related information, also boot and runtime service calls that are

available to the operating system and its loader. The following benefits are available when the Boot Mode is set to UEFI:

○ Support for drive partitions larger than 2 TB.

○ Enhanced security (e.g., UEFI Secure Boot).

○ Faster boot time.

NOTE:

You must use only the UEFI boot mode in order to boot from NVMe drives.

View Boot Settings

To view the Boot Settings screen, perform the following steps:

Steps

1. Turn on, or restart your system.

2. Press F2 immediately after you see the following message:

F2 = System Setup

NOTE:

If your operating system begins to load before you press F2, wait for the system to finish booting, and then

restart your system and try again.

3. On the System Setup Main Menu screen, click System BIOS.

4. On the System BIOS screen, click Boot Settings.

Pre-operating system management applications