Dell Force10 MXL 10 GbE 시작하기 매뉴얼 - 페이지 33

{카테고리_이름} Dell Force10 MXL 10 GbE에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Force10 MXL 10 GbE 38 페이지. 10/40gbe blade switches
Dell Force10 MXL 10 GbE에 대해서도 마찬가지입니다: 매뉴얼 (27 페이지)

페이지 인쇄

Next Steps

If you installed the MXL 10/40GbE Switch in a stack, you can configure

additional settings for switch stacking.

For information about how to create different stacking scenarios, refer to the

Ethernet Stacking white paper on the Dell Support and Dell Networking

White Papers websites at:

http://support.dell.com/manuals

http://en.community.dell.com/techcenter/networking/w/wiki/networking-

whitepapers.aspx

For information about how to configure stacking, refer to the User's

Configuration Guide for the Dell Force10 MXL 10/40 GbE Switch IO Module

on the Dell Support website at http://support.dell.com/manuals.

•

You can customize the MXL 10/40GbE Switch for use in your data center

network by configuring software features as necessary. To perform

additional switch configuration, do one of the following:

•

For remote out-of-band management, enter the OOB management

interface IP address into a Telnet or SSH client and log in to the

switch using the user ID and password to access the CLI.

•

For local management, use the attached console connection to log in

to the CLI.

•

For remote in-band management from a network management

station, enter the VLAN IP address of the management port and log in

to the switch to access the CLI.

For information about how to configure software settings, refer to the User's

Configuration Guide for the Dell Force10 MXL 10/40 GbE Switch IO Module

on the Dell Support website at http://support.dell.com/manuals.

Next Steps