Dell Force10 S2410-01-10GE-24P 매뉴얼 - 페이지 23

{카테고리_이름} Dell Force10 S2410-01-10GE-24P에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Force10 S2410-01-10GE-24P 42 페이지. Installing the s2410 system
Dell Force10 S2410-01-10GE-24P에 대해서도 마찬가지입니다: 애플리케이션 노트 (6 페이지), 빠른 시작 매뉴얼 (31 페이지)

페이지 인쇄

1. Physical Interfaces

Accessing Ports

This chapter contains the following sections:

•

Accessing the Console Port

•

Accessing the Ethernet Management Port on page 24

•

Accessing CX4 Ports on page 24

•

Accessing XFP Ports on page 25

Accessing the Console Port

You must first connect the console port to a management terminal in order to use the Command Line

Interface (CLI) to set up alternative management interfaces, such as an SFTOS Web User Interface

connection to the Ethernet Management port (see

For more on using alternative management interfaces, see the S2410 Quick Reference or the Getting

Started chapter of the SFTOS Configuration Guide for the S2410.

Connect the RJ-45/DB-9

adapter that is shipped with

the S2410 system to the RJ-

45 cable.

Console port pinout:

Pin 1 = NC (unused)

Pin 2 = DTR (output)

Pin 3 = TxD (output)

Pin 4 = GND

Pin 5 = GND

Pin 6 = RxD (input)

Pin 7 = DSR (input)

Pin 8 = NC

To access the console port, use the following the procedure:

CAUTION: You must use a rollover cable (same as used for the E-Series) to connect to the console port. This

is in contrast to the straight-through cable used on other S-Series models. In more detail, the cable

connections are pin 1 to pin 8, pin 2 to pin 7, pin 3 to pin 6, pin 4 to pin 5, and the inverse for pins 5 through 8.

Step

Task

If necessary, connect the RJ-45/DB-9 adapter that is shipped with the S2410 system to the end of the RJ-45 cable

that will connect to your terminal.

Verify your terminal default settings match the default settings, as listed above, on the console port:

Figure 5-1. S2410 Console Port

Accessing the Ethernet Management Port on page

Set your initial console terminal settings

to match the default console settings on

the switch:

• 9600 baud rate

• No parity

• 8 data bits

• 1 stop bit

• No flow control (console port only)

After establishing a connection, you can

modify the settings to match at each end

of the connection.

24).

Accessing Ports