Dell Force10 S50N Series 빠른 시작 매뉴얼 - 페이지 16

{카테고리_이름} Dell Force10 S50N Series에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Force10 S50N Series 25 페이지. Rapid equallogic configuration series configuration introduction array: ps4100 host: vmware esxi
Dell Force10 S50N Series에 대해서도 마찬가지입니다: 구현 매뉴얼 (9 페이지)

페이지 인쇄

Step

Task

Install the RJ-45 copper cable that is shipped with the S50V system into the

console port.

CAUTION: You must install a straight-through RJ-45 copper cable

(a standard Ethernet cable) into the console port. This is different from

many other implementations that require an Ethernet crossover cable (or

rollover cable). If connecting to a terminal server and using a crossover

cable, daisychain another crossover cable to effectively get a straight-

through cable connection. Many console terminal servers use octopus

cables that are crossover cables. To accommodate the octopus cable,

connect an additional crossover cable, as above, to effectively install a

straight-through cable.

If necessary, connect the RJ-45/DB-9 adapter that is shipped with the S50V

system to the end of the RJ-45 cable that will connect to your terminal.

Set your initial console terminal settings to match the default console settings on

the switch.

9600 baud rate

No parity

8 data bits

1 stop bit

No flow control (console port only)

After establishing a connection, you can modify the settings to match at each

end of the connection.

Accessing the Console Port

Connect the RJ-45/DB-9 adapter that is shipped with the S50V system to the RJ-

45 cable.

Table 2-1. Pin Assignments for Console Port

Signal

RJ-45 Pinout

RXD

Installing the Software