Dell PowerEdge 300 매뉴얼 확인 - 페이지 23
{카테고리_이름} Dell PowerEdge 300에 대한 매뉴얼 확인을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerEdge 300 27 페이지. Power supply update
Dell PowerEdge 300에 대해서도 마찬가지입니다: 업데이트 (2 페이지)
페이지 인쇄support.dell.com
Troubleshooting the Diskette Drive
Subsystem
If the monitor displays a system error message indicating a diskette drive problem
during execution of either the boot routine or the Dell Diagnostics, the problem may
be caused by any of the following conditions:
•
The system configuration settings do not match the physical diskette subsystem
configuration.
•
The diskette drive cable is not properly connected or is faulty.
•
An expansion card is interfering with proper drive operations.
•
A diskette drive may be improperly configured.
•
The diskette drive is faulty.
•
The computer's power supply is not providing sufficient power for the drives.
•
The computer's diskette drive logic is faulty.
Follow these steps to troubleshoot the diskette drive subsystem:
1.
Enter the System Setup program, and verify that the system is configured cor-
rectly for the Diskette Drive A setting.
See "Using the System Setup Program" in the User's Guide for instructions.
2.
If the system configuration settings are incorrect, make the necessary correc-
tions in the System Setup program, and then reboot the system.
3.
Run the Diskette Drives test group in the Dell Diagnostics to see whether the
diskette drive subsystem now works correctly.
See Chapter 5 "Running the Dell Diagnostics," for more information.
Did the tests run successfully?
Yes. If you were in the middle of another procedure, continue with the next step
in the procedure you were performing.
No. Go to step 4.
4.
Turn off the system, including any attached peripherals, and disconnect the sys-
tem from its electrical outlet.
CAUTION: See "Protecting Against Electrostatic Discharge" in the safety
instructions at the front of this guide.
5.
Remove the computer cover.
See "Removing the Computer Cover," found earlier in this chapter.
Checking Inside the Computer 7-23