Dell PowerEdge 850 사용자 설명서 - 페이지 16

{카테고리_이름} Dell PowerEdge 850에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerEdge 850 23 페이지. Information update - dell openmanage server support kit version 4.3 (.pdf)
Dell PowerEdge 850에 대해서도 마찬가지입니다: 시스템 진단 정보 업데이트 (2 페이지), 설치 매뉴얼 (28 페이지), 정보 업데이트 (18 페이지)

페이지 인쇄

Deleting or Changing an Existing Setup Password

1. Enter the System Setup program and select the System Security option.

2. Highlight the Setup Password option, press <Enter> to access the setup password window, and press <Enter> twice to clear the existing setup

password.

The setting changes to Not Enabled.

3. If you want to assign a new setup password, perform the steps in

Disabling a Forgotten Password

See your Installation and Troubleshooting Guide.

Baseboard Management Controller Configuration

The Baseboard Management Controller (BMC) enables configuring, monitoring, and recovery of systems remotely. BMC provides the following features:

Uses the system's serial port and integrated NIC

Fault logging and SNMP alerting

Access to system event log and sensor status

Control of system functions including power on and off

Support is independent of the system's power or operating state

Provides text console redirection for system setup, text-based utilities, and operating system consoles

NOTE:

To remotely access the BMC through the integrated NIC, you must connect the network connection to integrated NIC1.

For additional information on using BMC, see the documentation for the BMC and systems management applications.

Entering the BMC Setup Module

1. Turn on or restart your system.

2. Press <Ctrl-E> when prompted after POST.

If your operating system begins to load before you press <Crtl-E>, allow the system to finish booting, and then restart your system and try again.

BMC Setup Module Options

For information about the BMC Setup Module options and how to configure the emergency management port (EMP), see the BMC User's Guide.

Back to Contents Page

"Assigning a Setup

Password."